LBL Lighting MO Chandelier Single Tier Round Surf Xfmr - Manual

1
Installation Instructions for
Round Monorail Chandelier 1.0 HS130_S
980MRLRCH
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and DISCONNECT POWER TO
THE ELECTRICAL BOX.
Chandeliers
GENERAL PRODUCT INFORMATION:
This product is ETL listed only when all the products used are
supplied by LBL Lighting, is suitable only for dry locations and
approved for use at any height above the finished floor.
A typical installation is shown. Specific installation must be in
accordance with local electrical codes.
This product may be dimmed only with a low voltage electronic
dimmer. Using a dimmer not designed for low voltage electronic
applications may cause undesirable noise and potentially shorten
the life of the transformer.
This product is intended for use with LBL Lighting low voltage
lighting fixtures only.
Read all instructions thoroughly. Read "Important Safety
Information" on next column before proceeding with the
installation.
IMPORTANT SAFETY INFORMATION
Do not conceal or extend bus bar conductors through a building
wall.
Do not install this lighting system in a damp or wet location.
To reduce the risk of fire and burns, do not install this lighting
system where the uninsulated open bus bar conductors can be
shorted or contact any conductive materials.
To reduce the risk of the system overheating and possibly causing a
fire, make sure all the connections are tight.
Do not install fixture assemblies closer than six inches to curtains
or similarly combustible materials.
Turn the electrical power off before modifying the lighting system in
any way.
The fixtures used with the system must be identified to be used
with the corresponding system.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).
Load the circuit to no more than the maximum rated capacity of
the transformer as specified.