LBL Lighting Twilight 20 Chandelier - Manual

1
Installation Instructions for
Twilight 12, 20 1.1 HS44_410_
980TWIL20CH
G P I : ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box with
round plaster ring or an octagon electrical box.
This product is suitable for indoor dry locations only.
This product can be dimmed with a low-voltage electronic dimmer.
Install the Canopy
Remove the two cap nuts to lift the backplate out of the
canopy.
CAP NUT
CANOPY
BACKPLATE
Screw the crossbar assembly onto the backplate to form an
“X” and secure it to the backplate with a nut.
Screw the threaded nipple onto the crossbar so that 1/8” to
1/4” is exposed on the other side of the crossbar.
Secure the threaded nipple in position by tightening the nut
against the crossbar.
CROSSBAR
NUT
1/4"
THREADED NIPPLE
BACKPLATE
NUT
CROSSBAR
Connect the fixture to a suitable ground in accordance with
local electrical codes.
Mount the crossbar assembly to the electrical box with two
#8-32 screws.
#8-32 SCREW
5
Chandeliers
1A
1B
1C
1D
1
2
3
4
5
6
1 1
3
2
4
5
6
6
CAUTION - RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.