Siemens 30inc Warming Drawer - Manual (Page 9)

9
The control panel beeps to confirm an entry. The timer beeps five times when the
time has elapsed.
The Hot Surface Indicator appears in the display when the glass bottom of the
warming drawer is hot. Do not touch the inside of the drawer during this time.
The H disappears when the drawer has again reached a safeĆtoĆtouch temperature.
If the warming drawer is open when it is connected, an H will appear. This is the
indicator for Hot Surface", even if the glass plate is cold. After closing the drawer,
the H will disappear if the glass is cold. The H will not disappear if the glass plate is
still hot.
Use this pad to switch off the warming drawer.
The signal light turns on when the drawer is in use.
It is flashing when the drawer is open, and indicates when the drawer is closed.
The temperature pads control the temperature of the drawer bottom.
Table1: Temperature Pad Settings
Setting Surface
Temperature of Drawer Bottom
low 140º F
med (medium) 170º F
high 200º F
plates 170º F + convection
See Table Temperature Recommendations" for recommended settings.
The timer can be set for any increment of 5 minutes. The minimum time is 5 minutes
and the maximum is 5 hour. During use, the timer automatically stops counting
down when the drawer is opened. It begins again when the drawer is closed.
When the time has elapsed, the timer beeps five times and the drawer automatically
turns off.
Changing the Timer
Use the + or Ć pad to change the time.
The appliance will only heat up if the drawer is closed correctly.
The signal lamp indicates.
Beep
Hot Surface Indicator (H)
off Pad
Signal Light
Temperature Pads
Timer