Matrix Orbital VK204-25 Legacy - Manual (Page 28)

Description This command will allow you to manually set the cursor position, which
controls the text insertion point, by specifying the [col] and [row] of the
new proposed cursor position.
NOTE If the cursor position is set past the end of a line it will wrap to the beginning of
the next line.
Remembered No
5.9 Go Home
Syntax Hexadecimal 0xFE 0x48
Decimal 254 72
ASCII 254 “H”
Description This command will return the cursor to the top left corner of the display
area, identified as row one, column one.
Remembered No
5.10 Move Cursor Back
Syntax Hexadecimal 0xFE 0x4C
Decimal 254 76
ASCII 254 “L”
Description This command will move the cursor back one space. If this command is
sent when the cursor is at the home position the cursor will wrap to the
last row / column position if line wrap is on. Sending this command will
not effect the text displayed on the module, however any characters that
are sent will over write the current characters that are being displayed.
Remembered No
5.11 Move Cursor Forward
Syntax Hexadecimal 0xFE 0x4D
Decimal 254 77
ASCII 254 “M”
Matrix Orbital VK204-25 24