Matrix Orbital VK204-25 Legacy - Manual (Page 18)

1. Power off the display module.
2. Place a Jumper on the Manual Override pins.
3. Power up the display module.
4. The display module is now set to its default values listed below in table 2 .
5. Edit and save settings.
Figure 20: Manual Override Jumper
Table 2: Default Values
Brightness 0x03
Baud Rate 19.2 kbps
I 2 C Slave Address 0x50
Data Lock False
RS232AutoTransmitData True
NOTE The display module will revert back to the old settings once turned off, unless the
settings are saved.
Matrix Orbital VK204-25 14