Wagner PaintREADY Spray Gun - Manual (Page 9)

English 9
Cleanup -
Cleaning the
spray gun
Start Before you begin:
When cleaning, use the appropriate cleaning
solution (warm, soapy water for latex materials;
mineral spirits for oil-based materials)
IMPORTanT: never clean nozzle or air holes in
the spray gun with sharp metal objects. Do not
use solvents or lubricants containing silicone.
Special cleanup instructions for use
with flammable solvents (must have
a flashpoint above 70ºF (21ºC):
• Always flush spray gun outside.
• Area must be free of flammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
1. Make sure power cord is
unplugged.
Push the tab below the trigger,
twist and separate the spray gun
from the turbine.
4. Remove the parts as shown.
Clean all parts with a cleaning
brush and the appropriate
cleaning solution.
To reassemble, see the
instructions on the next page.
2. Wipe the exterior of the cup and
gun until clean.
5. Clean the rear of the spray gun
(c) with the appropriate cleaning
solution. Use a thin layer of
petroleum jelly to lubricate the
O-ring (d).
3. Remove the adjustment ring (a)
carefully from the connecting nut
(b). Loosen the connecting nut.
1
4
(c)
(d)
2
5
(a)
(b)
3