Wagner PaintREADY Spray Gun - Manual (Page 5)

English 5
Material
Preparation
Start
Before spraying, the material being used may
need to be thinned with the proper solvent as
specified by the material manufacturer. Never
exceed the thinning advice given by the coating
manufacturer.
Do not thin with materials that have
a flashpoint below 70°F (21°C). The
material flashpoint should be shown
on the material container.
note: Material to be sprayed should always be
strained to remove any impurities in the paint
which may enter and clog the system. Impurities
in the paint will give poor performance and a
poor finish.
Thinning the material:
3. After the material has been
properly thinned and strained,
fill the container to the top of the
neck.
1. Stir the spraying material
thoroughly.
4. Carefully screw the cup back
onto the spray gun.
2. Unscrew the cup from the spray
gun.
3
1
4
2