Wagner SMART Power Roller System - Manual (Page 7)

7 English
Cleanup -
Purging the
Paint Hose
Start Note:
When you are finished with your project, follow
these steps to return any remaining material
left in the hose back into its container.
IMPORTANT: Make sure your floors and
furnishings are covered with drop cloths
during cleanup.
Before you begin cleaning:
When cleaning the Smart Power Roller, make
sure to use the appropriate cleaning solution
for the type of material used:
• If you used latex-based materials, use
warm, soapy water to clean the Smart
Power Roller.
• If you used oil-based materials, use
mineral spirits.
You will need:
• A large bucket with the appropriate
cleaning solution.
1. Place roller arm into rest area.
Turn the variable speed dial to 9.
Switch paint flow directional
switch to “REvERSE”.
4. Flip the paint flow directional
switch back to “PAINT”.
2. Fully press and release the
handle button to switch the
motor on.
5. Remove spatter shield.
Press locking tab and drop roller
cover assembly into a bucket
of the appropriate cleaning
solution.
3. Let the motor run for 2-3 minutes
to pull paint from the hoses back
into the paint can.
When finished, fully press and
release the handle button to switch
the motor off.
Note: If using the Smart Edge
Roller assembly, open the guard
and pull the roller cover off by hand.
Drop the roller cover into a bucket
of the appropriate cleaning solution.
IMPORTANT: Do not attempt to
remove the core and cap of the
Smart Edge Roller cover.
1
4
2
5
3
2-3 MINUTES
9
1
2
PRESS
PAINT
PRESS