Wagner SMART Power Roller System - Manual (Page 3)

3 English
Parts and
Components
Start General Description:
This high performance power roller is a
precision power tool used for both interior and
exterior painting and may be used with both
water (latex) and oil based paints.
IMPORTANT: Use of oil-based paints must
be limited to only those paints which can be
cleaned with mineral spirits. Latex paints
can be cleaned with soapy, lukewarm water.
DO NOT use hot water when cleaning or
flushing the unit.
Note: Some of the parts listed on this page
can be replaced by calling technical service.
See page 32 for part numbers.
Specifications:
Flow rate: 8 - 20 fluid oz. per minute (flow rate
will depend on thickness of paint)
Power source: 120 VAC
Power requirement: 60 Hz current.
Capability: Most oil and water based paints
and stains. Do not use with lacquers, lacquer
thinners or any other solvent with a flash point
below 100° F (38°C).
Questions?
Call Wagner Technical Service at:
1-800-760-3844
Register your product online at:
www.wagnerspraytech.com
Item Description
a Roller rest area
b Can lid
c Suction tube
d Tower
e Variable speed dial
f Paint flow reverse switch
g Spatter shield
Item Description
h 9” Roller assembly
h1 - 3/8” nap roller cover
h2 - Roller cap
h3 - Roller core
i Roller arm
j Quick-release tabs
k Handle button
Item Description
l Roller handle
m Hose
n Extension
o Smart Edge™ Roller
o1 - Roller cover
p 3/4” nap roller cover
e
0 9
Variable Speed
f
a
c
d
f
e
j
j
k
l
m
n
p
i
b
h1
h3
o1
h2
o
g
h
Paint can shown
for reference only.
Not included.
Note: Some parts are not
assembled out of the box. See
“Setup” section, page 4.