Wagner SMART Power Roller System - Manual (Page 10)

English 10
Troubleshooting
Problem A: The pump will not run.
Cause Solution
1. The power cord is unplugged, or no power in outlet. Plug the power cord into 120V outlet
2. The variable speed dial is turned to 0 (OFF) and handle button has not been pressed. Turn variable speed dial to higher setting (1-9) and press handle button.
3. There is a kink in the air hose. Unkink the air hose.
If unit still fails to run, call Customer Service.
4. Fluids have entered the handle assembly. Call Customer Service.
Problem B: Paint fails to load the roller.
Cause Solution
1. The suction tube is not immersed in the paint. Fully immerse the tube into the paint.
2. There is an obstruction in the suction tube. Remove the obstruction.
3. The paint can is empty. Fill the paint can.
Problem C: The motor does not turn off.
Cause Solution
1. The handle button is activated. Press and release handle button.
2. There is a kink in the air hose. Unkink the air hose.
3. There is an air switch malfunction. Unplug unit, then call Customer Service.
Problem D: There is paint leakage.
Cause Solution
1. The seal on the roller arm is backwards. Turn the seal around.
2. The seal and cap were not properly cleaned. Clean and properly lubricate.
3. The O-ring and the connecting area were not cleaned properly. Clean and properly lubricate (pg 8-9).
4. Paint residue on connecting areas. Clean connecting areas.
5. The O-rings are damaged or missing. Replace the O-rings*
6. The roller cover is worn or damaged. Replace the roller cover*.
7. The roller core or cap is worn or damaged. Replace the roller core or cap*.
8. The bearing areas on the roller arm are worn. Call Customer Service
9. The pump tube is punctured. Call Customer Service
10. The paint hose is damaged. Call Customer Service
This unit contains no serviceable
electrical parts. Do not attempt to
service the unit yourself.
* Replacement parts available by calling customer service