MagTek IntelliStripe 60 99875135 - Manual (Page 29)

21
APPENDIX B. BEZEL CONFIGURATION AND MOUNTING
The Bezel is attached to the unit by four screws (Mounting inserts M3.5 x 5 Minimum deep).
The four screws are inserted into the front flange slots to retain the unit to the bezel. Figure B-1
shows the position and the dimensions of the flanges.
Figure B-2 shows the orientation and dimensions of the bezel and recommended dimensions for
the panel opening. Four screws that mount the Bezel to the panel are also M3.5. The length of
the screws depends on the panel thickness, washers, and spacers used in mounting the panel.
Figure B-1. Flanges for Bezel Mounting