Videotec HOV - Manual (Page 8)

EN - English - I
nstruc
tions manual
6 MNVCHOV32_1351_EN
6 Assembling and installing
The assembly and installation must be
performed only by skilled personnel.
6.1 Installation
6.1.1 How to open the housing
Loosen the 2 screws on the side, turn the cover and
the upper half of the body about the opening hinge
axis.
Fig. 1
6.1.2 How to install the camera
Power supply can be provided by the board
supplied with the product. Make sure the
voltage values are appropriate.
Open the housing as described previously (6.1.1 How
to open the housing, page 6).
Extract the internal support slide by partially
loosening the fastening screws (01).
Move the slide, by sliding it until the holes coincide
with the slide locking screws (02).
Fasten the camera with the 1/4" screw. If necessary,
use the supplied spacers to correctly position the
camera and optics (03).
01
03
02
Fig. 2
Reposition the internal slide by tightening the
previously loosened screws.
Remove the conductors protective sheathing and
connect them to terminal (J5, 6.1.3 Board description,
page 7).
The camera’s power supply cable conductors must be
tied up with a cable tie next to the terminal. Keep the
signalling and power supply cables separated from
each other.