Videotec NXM36 - Manual (Page 7)

Instruc
tions manual - English - EN
5
6.1.2 How to install the camera
This chapter described how to install the camera into
the housing.
Open the housing following the instructions given
above. (6.1.1 How to open the housing, page 4).
Fit the camera on the slide, using the insulating plate
and the supplied 1/4” screw. If necessary, use the
spacers to position the camera and optics correctly.
Fig. 3
Feed the cables through the cable grip, and make the
necessary electrical connections, ensuring that the
cable grips are holding firmly.
6.1.2.1 Version 12Vdc/24Vac
When the power supply voltage is 24Vac the circuit
will be connected by the terminals shown.
Heater OUT 12Vdc/24Vac OUT 12Vdc/24Vac
IN 12Vdc/24Vac
Fig. 4
6.1.2.2 Version 115/230Vac
OUT 115/230Vac
IN 115/230Vac
Heater OUT 115/230Vac
Fig. 5
6.1.3 Closing the housing
Before closing the housing reinsert the bottom
orientating the slide according to the installation
required, on the wall bracket or on the Pan & tilt
head, for the right camera fitting. (6.1.1 Installing the
housing, page 6).
Close the housing taking care not to damage the
sealing ring. Make sure that the sealing ring is
correctly fitted in its position.
Pay attention to the fixing. Tightening
torque: 4Nm max.