Videotec EXPT - Manual (Page 15)

EN - English - I
nstruc
tions manual
13
h The manufacturer declines all liability for
damage to any of the apparatus mentioned
in this handbook, when resulting from
tampering, use of non-original spare parts,
and from installation and maintenance/
repairs performed by non-authorised, non-
skilled personnel.
j In all such circumstances, the housing
should be sent to the workshop for the
necessary repairs or maintenance.
8.2 Parts
j It is necessary to provide the series number
of the product requiring assistance, so that
parts may be ordered ([email protected]).
8.3 Repairs
j For any other maintenance operation
the housing must be sent to VIDEOTEC,
upon request for authorisation to return it
([email protected]).
9 Disposal of waste
materials
n This symbol mark and recycle system
are applied only to EU countries and not
applied to the countries in the other area of
the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.
• Inspecting the cables - The cables should not
show signs of damage or wear, which could
generate hazardous situations; in this case
extraordinary maintenance is necessary.
• Changing the Mylar tape (version with glass
protection device) - This should be done in the
presence of the minimum safety conditions as
indicated in the instructions for safe operation. To
carry out the operation, unscrew the four screws
fastening the glass protection cover in order to
replace the set of reels holding the dirty tape by
those with the clean tape, by simply sliding them
out.
• Opening the housing to change the camera -
Check the condition of the back cover gasket; if it
needs changing use only the one supplied with the
housing or, failing that, use only VIDEOTEC original
spare parts (see the instructions for Changing the
back cover gasket.
8.1.2 Extraordinary (to be done only
under particular circumstances):
• Changing the front unit with glass (or the glass
protection unit when present);
• Changing the inner slide unit with heater wiring
and electrical connection board, using the
appropriate spare part for versions with or without
the glass protection device;
• Hazardous wear or damage to cables;
• Pan & tilt failure;
• Camera or lens failure;
• Explosion in or near the P&T;
• Any other situation in which the P&T or control
unit has to be opened.
h For damage to any parts that are not
indicated above, repair or replacement
must be done by VIDEOTEC.
h Whenever replacing the parts as indicated,
always use VIDEOTEC original spare parts
and meticulously follow the maintenance
instructions supplied with every spare parts
kit.