Burr King BK75 User Manual
Page 22
Cabinet Dust Collector, Series 50 to 80
21
Exhaust Silencer
If an exhaust silencer was ordered with the unit,
the mounting holes are pre-drilled.
To install an add-on silencer:
1. Remove the top door assembly and set aside.
2. Place a piece of non-combustible cloth over the
filters in the clean-air chamber to protect them
from drilling chips.
3. Use a .116-in diameter drill bit to drill eight
holes in the collector top as shown.
4. Position the exhaust silencer, align holes, and
fasten securely with #7 x 1/2-in screws
supplied.
5. Carefully remove the cloth protecting the
filters. Replace the top door assembly and
tighten securely by hand.
Exhaust Silencer Installation
#7 x 1/2-in
self tapping screw
8 required
10.21
2.56
7.75
5.24
5.06
.116
8x
1.65
11.17
3.06
8.11
3.90
6.81
.116
8x
1.92
11.45
3.50
8.95
8.01
8.41
.116
8x
1.95
Series 50 Drill Location
Series 60 and 70 Drill Location
Series 80 Drill Location