Kenwood DDX3023 - Manual (Page 78)

78 English
Installing the Microphone
Unit (DDX6023BT/
DDX6053BT/ DDX4023BT/
DDX4053BT/DDX42BT only)
1 Check the installation position of the
microphone (accessory 7).
2 Remove oil and other dirt from the
installation surface.
3 Install the microphone.
4 Wire the microphone cable up to the unit
with it secured at several positions using
tape or the like.
⁄
• Install the microphone as far as possible from the
mobile phone.
Fix a cable with clamps (commercially
available).
Peel the release coated paper of double-face
adhesive tape to fix on the place shown above.
Adjust the direction of the microphone to the
driver.
Accessory 7
Removing the Unit
(DDX4023BT/DDX4053BT/
DDX3023/DDX3053/
DDX42BT/DDX35 only)
• For removing DDX6023BT/DDX6053BT, ☞ page 73.
1 Remove the trim plate by referring to
the removal procedure in the section
“Removing the Trim Plate”.
2 Insert the two extraction keys 4 deeply
into the slots on each side, as shown.
Accessory 4
3 Lower the extraction keyl toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
⁄
• Be careful to avoid injury from the catch pins on
the removal tool.
4 Pull the unit all the way out with your
hands, being careful not to drop it.
EN_GET0909-001A_EQ.indb 78 EN_GET0909-001A_EQ.indb 78 12/11/13 15:28 12/11/13 15:28