Kenwood KMM-257 - Manual (Page 17)

15 ENGLISH |
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
· terminal of the car battery.
2 Connect the wires properly. (See Wiring connection. (➜ 16))
3 Install the unit to your car. (See Installing the unit (in-dash mounting).)
4 Connect the
· terminal of the car battery.
5 Reset the unit. (➜ 3)
INSTALLATION / CONNECTION
Do the required
wiring. (➜ 16)
Dashboard of
your car
Bend the appropriate tabs
to hold the mounting sleeve
firmly in place.
How to remove the unit
Installating the unit (in-dash mounting)
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
EN_KMM-357SD[EN]f.indd 15 EN_KMM-357SD[EN]f.indd 15 12/17/12 5:10:28 PM 12/17/12 5:10:28 PM