Kenwood K-521-B - Manual (Page 70)

70 K-521
Troubleshooting
Symptoms Solution Ref. page
CD
A CD does not play back
when loaded.
Load the disc correctly with the label side facing upward. z
Clean the disc. (See .) z
Allow any condensation to evaporate. (See z
condensation.)
26
73
73
No sound output Press the z [CD E] key.
Clean the disc. (See .) z
26
73
Playback skips. Clean the disc. (See .) z 73
Some audio fi les can't
play back. The system will not play audio fi les that are corrupted. z
Make sure the audio fi le is supported for playback on the z
system.
23
Delay until playback
starts. There may be a delay prior to playback if there are large z
numbers of folders.
28
TAG information is not
displayed correctly. Refer to to check which TAG z
information can be displayed on this system.
23
Symptoms Solution Ref. page
iPod
The iPod cannot be at-
tached fi rmly. Check to see whether the correct Dock adapter is used. z
Then check to see whether the connector between the
iPod and the system is not damaged, and reconnect
them.
12
The iPod does not pro-
vide sound. The iPod is not properly connected. Remove the iPod z
from the system, and then connect it again.
12
The iPod cannot be
charged. The iPod is not properly connected. Remove the iPod z
from the system, and then connect it again.
12
Symptoms Solution Ref. page
USB
No sound output when
USB flash memory or a USB
audio player is connected. Plug in the USB fl ash memory correctly. z
Connect the USB cable correctly. z
Check to make sure the USB audio player is turned on. z
12
40
K-521E_B60-5813-08_01_GVT0294-002A.indb 70 K-521E_B60-5813-08_01_GVT0294-002A.indb 70 09.10.26 4:32:02 PM 09.10.26 4:32:02 PM