Kenwood K-521-B - Manual (Page 11)

11 English
Connecting the System
The antenna supplied with the system is a basic antenna for indoor use. For stable signal reception, the
use of an outdoor antenna (commercially available) is recommended. To connect an outdoor antenna, fi rst
remove the indoor antenna.
Connecting the FM indoor antenna
Preparing the ends of the speaker cords z
Twist the plastic sleeve on the end of the cord as you
pull it off .
Notes on connecting the
speaker cords
Never short-circuit the positive (+) and negative (–) ends of the
speaker cords. (Do not touch the + and - cords together.) Mis-
takenly reversing the positive and negative polarity will result in
unnatural sound and unclear sound.
Connecting the speakers
Microcomputer malfunctions
If the system is connected correctly and still does not operate
normally or shows display errors, reset the microcomputer. (P.71)
The antenna supplied with the system is for indoor use. Place it as far as possible away from the main unit,
your TV set, the speaker cords and the power cord and point it in the direction that gives the best reception.
Connecting the AM loop antenna
1 2 3
Connecting the antenna cord z
As shown on the right, connec t the AM
antenna cord [AM] and [
MGND] terminals.
1 2 3 4
Connecting the speaker cords to the speaker z
Connecting the speaker cords to the main unit z
K-521E_B60-5813-08_01_GVT0294-002A.indb 11 K-521E_B60-5813-08_01_GVT0294-002A.indb 11 09.10.26 4:31:52 PM 09.10.26 4:31:52 PM