Kenwood K-525-S - Manual (Page 9)

1 2 3 3
1
2
4
3
4
3
K-525 16 17 English
This symbol indicates an operation on the main unit. When it is marked,
perform the operation by pressing the required button(s) on the main unit.
This symbol indicates an operation on the remote control unit. When it is marked,
perform the operation by pressing the required button(s) on the remote control unit.
If both are marked, the operation is available either on the remote control unit
or this unit.
1
Turn the system ON (OFF).
Press [ K].
• Pressing the play/pause [ E] button of the
desired audio input source also turns the system
ON (page 15, "One touch operation function").
• Pressing [ K] while the system is ON switches it OFF
(standby mode).
2
Select the audio source.
Press the play/pause button of the desired audio
source.
Press [TUNER]/ [AUX]/ [D-IN]/
[D.AUDIO E ]/ [CD E ]/ [iPod E ]/
[USB E ].
Press [INPUT SELECTOR].
Press [INPUT SELECTOR] on main unit to switch
the input source in order of [TUNER] R [CD] R
[iPod] R [USB] R [D,AUDIO] R [DIGITAL IN]R
[AUX].
With the CD/iPod inputs, loading a disc or iPod/
iPhone in this unit selects the corresponding
input source automatically.
3
Set the source to be played.
How to load a disc
Hold the disc with the label side up and insert
it into the centre of the disc slot. "LOADING" is
displayed and the input source is switched to CD
. When the disc is loaded, " " lights and
playback starts automatically.
■ To eject the disc...
Press CD EJECT[ L]. "EJECT" is displayed and the
disc is ejected.
How to connect a USB device
Hold the device in the correct orientation and
insert the connector all the way. When you select
USB source, "READING" is displayed and the input
source is switched to USB . " " lights.
■ To remove the USB device...
After stopping, set the system to the standby
mode and pull out the USB device.
How to install iPod/iPhone
Install iPod/IPhone on the unit. "READING" is
displayed and the input source is switched to iPod
and playback starts automatically.
■ To remove the iPod/iPhone...
After stopping, set the system to the standby
mode and pull out the iPod/iPhone.
4
Start playback.
Play the connected input source.
■ When you select USB source.
Press [USB E]/[E].
■ To stop playback of CD/USB/D.AUDIO...
Press [ F] during playback.
Basic Operation
Pla
ying music
Adjusting the volume
Adjust using [VOLUME].
Increasing the
volume level
Decreasing the
volume level
Increasing the
volume level
Decreasing the
volume level
Adjust in the range from 0 to 40 (max.).
• Press and hold the button to vary the volume level
at a high speed.
Muting the sound temporarily
Press [MUTE].
"MUTE" blinks on the display.
■ To cancel muting...
Press [MUTE] again (this resumes the original volume)
or adjust the volume.