Kenwood K-525-S - Manual (Page 26)

K-525 50 51 English
Main
tenanc
e
Care and Storage
Care and storage of main unit
Do not place in the following locations
• Place exposed to direct sunlight.
• Place subjected to excessive humidity or dirt.
• Place exposed to direct heat from heating equipment.
Be careful against condensation
When the diff erence in temperatures between the
main unit and the environmental air is large, dew may
be condensed inside the main unit and may cause
malfunction of the main unit. If this happens, leave the
main unit for a few hours until its internal mechanisms
are dried up.
Take special care against condensation when the main
unit is moved between places with a large temperature
diff erence or into a room with high humidity.
When the unit becomes dirty
When the front panel or case gets dirty, wipe with a soft
dry cloth. Do not use lacquer thinner, benzine, alcohol
or contact revitalizer for these chemicals will cause
discoloration or deformation.
Windows Media is a registered trademark or trademark
of Microsoft Corporation in the United States and other
countries.
Other system names and product names are generally
trademarks or registered trademarks of their developers.
However, note that the text in this manual does not use the
TM and ® markings to them.
Specifi cations
[Amplifi er section]
Rated power
Output power ……… 20 W + 20 W RMS (1 kHz, 10 W, 8 Ω)
Total harmonic distortion ………………………… 0.05 %
(1kHz, 1W, 8 Ω, 30 kHz LPF)
Frequency response ……………………… 10 Hz ~ 20 kHz
Tone control characteristics
BASS ……………………………………… ±6 dB (100 Hz)
TREBLE …………………………………… ±6 dB (10 kHz)
Input terminals (Sensitivity/impedance)
D.AUDIO/AUX (INPUT LEVEL 0) ……… 300 mV / 27 kΩ
Output terminals (Level/impedance)
Recording output (REC OUT LEVEL 0)
………………………………………… 900 mV / 10 kΩ
[Tuner section]
FM tuner
Tuning frequency range ………87.50 MHz ~ 108.00 MHz
Antenna impedance ………………… 75 Ω unbalanced
[CD section]
Read method
……………… Non-contact optical readout (laser diode)
D/A Converter ………………………………………… 1 bit
Oversampling ……………………………8 fs (352.8 kHz)
[USB section]
Compatible USB devices
………………………… USB mass storage class devices
Interface ……… USB 2.0 (Full speed), USB 1.1 compatible
Compatible fi le system ………………………… FAT 16/32
Maximum supply current ………………………… 500 mA
[Digital section]
Compatible sampling frequencies …… 32k/44.1k/48k Hz
Input connectors (Sensitivity/Wavelength) ……… Optical
(−15 dbm to −24 dbm/660 nm ±30 nm)
[Speakers section]
Enclosure …………………………… Bass refl ex system
Speakers …………………………………80 mm cone type
Impedance …………………………………………… 8 Ω
Maximum input ……………………………………… 30 W
[General section]
Power consumption …………………………………… 25 W
Power consumption in standby mode ……… 0.5 W or less
Dimensions (Max.) ………………………… Width 390 mm
Height 119.5 mm
Depth 277.5 mm
Weight ………………………………………… 5.8 kg (net)
• Design and specifi cations are subject to change
without notice.
• The system may be unable to manifest the full
performance in an extremely cold place (under the
water freezing temperature).
Manufactured under license from DTS Licensing
Limited. DTS and the Symbol are registered
trademarks, & DTS Surround Sensation and the DTS
logos are trademark of DTS, Inc. Product includes
software. © DTS, Inc. All Rights Reserved.
• “Made for iPod,” and “Made for iPhone” mean that an
electronic accessory has been designed to connect spe-
cifically to iPod, or iPhone, respectively, and has been
certified by the developer to meet Apple performance
standards. Apple is not responsible for the operation of
this device or its compliance with safety and regulatory
standards. Please note that the use of this accessory
with iPod, or iPhone may affect wireless performance.
• iPhone, iPod, iPod classic, iPod nano, and iPod touch
are trademarks of Apple Inc., registered in the U.S. and
other countries.