Siemens KI39FP60 - Manual (Page 43)

en
43
Fault Possible cause Remedial action
Appliance is not
cooling, temperature
display and light
are lit. Showroom mode is
switched on. Hold down alarm button, Fig 2/1,
for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
The light does
not function. The LED light
is defective. See chapter “Light (LED)” section.
Appliance was open
too long.
Light is switched off
after approx. 10 min. When the appliance is closed
and opened, the light is on again.
Temperature display
refrigerator
compartment is
flashing. Fig. 2/7 Appliance opened
frequently. Do not open the appliance
unnecessarily.
Too much food was
placed in
the compartment. Before placing food in the freezer,
press the “super” button.
The ventilation
openings have been
covered. Remove obstacles.
The “cool-fresh”
compartment is too
warm or too cold. The fixed setting has
been set too high
or too low (e.g. if there
is frost in the “cool-
fresh” compartment). The temperature in the cool-fresh
compartment can be set to be 2
steps warmer and/or colder, Fig. 2.
If the refrigerator compartment
temperature is set to 4, the cool-
fresh compartment has
a temperature of almost 0 °C.
1. Press super button on refrigerator
compartment 5 for 3 seconds
until a signal sounds.
Temperature display
on refrigerator compartment 7
flickers.
2. Change the setting using
the temperature setting button
on refrigerator compartment 6.
Setting 2 – coldest setting
Setting 8 – warmest setting
After one minute, the set
temperature is saved.