Siemens TE506209RW - Manual (Page 17)

13
de en
O Do not put the following items in
the dishwasher: drip tray panel (8a),
drawer (4), brewing unit (5a)�
N The following items are dishwasher-
safe: drip tray for coffee outlet (8c),
coffee grounds container (8b), grate
for coffee outlet (8d), aroma cover (2)
and measuring spoon (19)�
● Wipe out the inside of the appliance (tray
holders and drawer)�
Important: Drip tray for coffee outlet (8c)
and coffee grounds container (8b) should
be emptied and cleaned daily to prevent
mould from developing�
N.B.: If the appliance is cold when switched
on with the power switch O / I (9) or if it
switches off automatically after coffee has
been dispensed, it rinses automatically� In
other words the system cleans itself�
Important: If the appliance has not been
used for a prolonged period of time (e�g�
after a vacation), clean the entire appliance
thoroughly, including the milk system and
brewing unit�
Cleaning the milk system
If the milk system was not cleaned after
milk has been dispensed, after a certain
amount of time the message Clean milk
system! will appear on the display�
Clean the milk system immediately after
use! To clean, leave the rotary selector (6b)
in the same position it was in when last
used�
To pre-clean the milk system automatically:
1� Select
f
by turning the rotary knob (15)�
2� Place a tall, empty container under the
outlet (6a)�
3� Push the outlet as close as possible to
the container�
4� Place the end of the milk tube (6c) into
the container�
5� Press the start button (10)�
The machine automatically releases water
into the container and vacuums it up again
via the milk tube to rinse the milk system�
The rinse procedure stops automatically
after about 1 minute�
6� Empty the container and clean the milk
tube (6c)�
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher)�
Dismantling the milk system for cleaning:
1� Pull the milk frother (6) forward out of
the appliance�
2� Dismantle the milk frother into its indi-
vidual parts (6a to 6d) (see figure C at
the start of the operating instructions)�
3� Clean the individual parts with a deter-
gent solution and a soft brush� If neces-
sary, soak in a warm detergent solution�
4� Rinse all parts with clear water and dry
them�