Siemens TE506209RW - Manual (Page 13)

9
de en
The filter is no longer effective when the
Change filter! display appears, or at
the latest after 2 months� It needs to be
replaced for reasons of hygiene and so
that there is no build-up of limescale (this
could damage the appliance)� Replacement
filters can be obtained from retailers or from
customer service (see “Accessories”)� If no
new filter is used, turn the filter setting to
No / Old �
Note: You can use the filter indicator to
mark the month in which you inserted the
filter. You can also mark the month in which
you will need to replace the filter next (at
the latest after two months)�
Note: If the appliance has not been used
for a prolonged period (e�g� vacation) the
filter should be rinsed before the appliance
is used again� To do so, dispense a cup of
hot water and pour it away�
Menu settings
You can adapt the appliance to your indi-
vidual needs in the menu settings�
1� Hold the
e
off / j button (13) down for
at least 3 seconds�
2� Press the
e
off / j button (13) repeat-
edly until the required menu item
appears in the display�
3� Select the required setting with the
upper rotary knob (15)�
4� Confirm by pressing the start
button (10)�
To leave the menu without making any
changes, turn the rotary selector to Exit and
press the start button (10)�
You can set the following:
Shut off : Here you can set the time
span after which the appliance automati-
cally switches off following the last drink
preparation� A time between 15 minutes and
4 hours can be set� The default time can be
shortened to save energy�
To save power you can specify a shorter
period�
Filter : Here you can set whether a water
filter is being used. If a water filter is not
being used, turn the setting to No / Old � If
a water filter is being used, turn the setting
to Activate filter . New water filters have
to be rinsed before use (see “Water filter”).
Start Calc‘n‘Clean : The service
programmes ( Calc‘n‘Clean / descaling /
cleaning ) can be selected manually
here� Press the start button (10) and run
the selected programme (see “Service
Programmes”)�
Temp. : The brewing temperature ( high /
middle / low ) can be set here�
Language : The display language can be
set here�
Water hardness : The water hardness
setting can be adjusted on this appliance�
It is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling programme
should be run� The factory setting for the
water hardness is 4�
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier�
Dip the test strip briefly in water, gently
shake off any drips, and check the result
after one minute�