Siemens TE506209RW - Manual (Page 16)

12
de en
Preparing milk froth and
warm milk
A Risk of burns!
The milk frother (6) gets very hot� Hold the
milk frother (6) by the plastic part only�
Tip: You can foam the milk first and then
dispense coffee, or foam the milk separately
and pour it onto the coffee�
The appliance must be ready for use�
1� Place a pre-warmed cup under outlet
(6a)�
2� Insert the milk tube (6c) into a milk
container�
3� Turn the rotary selector (6b) to “Milk
froth”
j
or “Warm milk”
i
�
4� Press the h / g button (12)�
The h / g button (12) flashes and
the appliance now heats up for approx�
20 seconds�
A Risk of burns!
Milk froth or warm milk comes out of the
milk frother (6) at high pressure� Splashes
of milk can scald� Do not touch the outlet
(6a) or aim it at anyone�
5� End the process by pressing the
h / g button (12)�
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1�5 % if
possible�
Important: Dried milk residue is difficult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use and rinse using the Clean milk
system programme�
Maintenance and daily
cleaning
A Risk of electric shock!
Unplug the appliance before cleaning it�
Never immerse the appliance in water�
Do not use a steam cleaner�
● Wipe the outside of the appliance with a
soft, damp cloth�
● Do not use abrasive cloths or cleaning
agents�
● Always remove any limescale, coffee,
milk or descaling fluid residue immedi-
ately� Such residue can cause corrosion�
● New sponge cloths may contain salts�
Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use�
● Pull the drip tray (8c) with the coffee
grounds container (8b) forward and out�
Remove the panel (8a) and the grate (8d)�
Empty and clean the drip tray and coffee
grounds container�
● Remove drawer (4) and clean�