Kenwood TH-K20A - Manual (Page 53)

45
Note:
◆
While Tone Alert is ON, there is no speaker output when a signal is received. To monitor
the signal, press and hold [MONI].
◆ When Tone Alert is ON, APO does not turn the power OFF.
◆ If you switch the transceiver OFF while the “ ” icon is blinking, the transceiver does not
back up the elapsed time.
◆ When Tone Alert is ON, you can use only the following keys: [ ], [MONI], [SQL], and
[LAMP].
POWER ON MESSAGE
You can change the Power ON Message (a maximum of 6 characters) when the
transceiver is turned ON.
1 Enter Menu mode and access Menu No. 1 (P.ON.MSG), then press [F].
• A blinking cursor appears.
2 Rotate the ENC control to select a character.
• You can enter the following alphanumeric characters:
0 ~ 9, A ~ Z, – (hyphen), / (slash) and a space.
3 Press [MR].
• The cursor will move to the next digit.
• You can move the cursor to the left or right by pressing [VFO] or [MR].
• Press
[CALL] to delete the character at the current cursor position.
4 Repeat steps 3 and 4 to enter up to 6 digits.
• Press [CALL] to delete the character at the current cursor position.
5 Press [F] to store the message.
6 Press [MENU] or [PTT] to exit Menu mode.
Note: If the Power ON Message is deleted, “TH-K20” or “TH-K40” is displayed.