Kenwood TH-K20A - Manual (Page 32)

24
MEMORY CHANNEL TRANSFER
MEMORY TO VFO TRANSFER
After retrieving frequencies and associated data from Memory Recall mode, you
can copy the data to the VFO. This function is useful, for example, when the
frequency you want to monitor is near the frequency stored in a memory channel.
1 Press [MR], then turn the ENC control to recall a desired memory channel.
2 Press [F] - [VFO] to copy the memory channel data to the VFO.
Note:
◆
When transferring an odd-split channel, the Reverse status, Offset direction, and
Transmit frequency are not transferred.
◆ You can also transfer the Program Scan memory channels (L0/U0 ~ L2/U2) and Priority
channel (Pr) to the VFO.
◆ When selecting the Call channel, rotating the ENC control will transfer the data to the
VFO.
CHANNEL TO CHANNEL TRANSFER
You can also copy channel information from one memory channel to another.
This function is useful when storing frequencies and associated data that you
temporarily change in Memory Recall mode.
1 Press [MR], then turn the ENC control to recall a desired memory channel.
2 Press [F] - [MR].
3 Select the memory channel where you would like the data copied, using the
ENC control.
4 Press [MR] to copy the memory channel data to the new channel.
Note: When transferring to the Program Scan memory channels (L0/U0 ~ L9/U9) and the
Priority channel (Pr), the Memory Channel Lockout information is not copied.
CHANNEL DISPLAY MODE
While in this mode, the transceiver displays only memory channel numbers (or
Memory names if they have been stored) instead of frequencies.
Press [PTT] + [MR] + Power ON.
• The transceiver displays the memory channel number in place of the operating
frequency.
To recover normal operation, turn the transceiver OFF and press [PTT] + [MR] +
Power ON again.