Kenwood TH-K20A - Manual (Page 37)

29
5 Press [MR] to store the data on the Priority Channel.
USING PRIORITY SCAN
1 Enter Menu mode and access Menu No. 15 (PR.SCAN), then press [F].
2 Rotate the ENC control to select “ON” , then press [F] to store the setting.
3 Press [MENU] or [PTT] to exit Menu mode.
• The “ ” icon appears when the Priority Scan is ON.
Note:
◆
If a signal is received on a Priority Channel with a CTCSS or DCS code programmed, the
Priority Channel is recalled only when the programmed tone/ code matches.
◆ Press and hold [MONI] to pause Priority Scan when the transceiver is not displaying the
Priority Channel. Release [MONI] to resume Priority Scan.
◆ If you clear the Priority Channel, Priority Scan stops.
◆ You can also press any key other than [MONI], [F], [SQL] (Squelch level adjustment),
[F] (1s) (Key lock) and [PTT] to exit Priority Scan while “ ” is blinking.
MEMORY CHANNEL LOCKOUT
You can lock out memory channels that you prefer not to monitor during Memory
Scan.
1 Press [MR] to enter Memory Recall Mode.
2 Rotate the ENC control to select the memory channel to be locked out.
3 Enter Menu mode and access Menu No. 13 (L.OUT), then press [F].
4 Rotate the ENC control to select “ON” , then press [F] to store the setting.
5 Press [MENU] or [PTT] to exit Menu mode.
• The “ ” icon appears below the memory channel number, indicating the channel
is locked out.
Note:
◆
The Program Scan channels (L0/U0 ~ L2/U2) and Priority Channel (Pr) cannot be locked
out.
◆ Even if a memory channel is locked out, you can perform Call Scan between the Call
Channel and the memory channel.