Kenwood DNX691HD - Manual (Page 23)

English с 23
С Connecting wires to terminals
A
A
+
+
+
+
MUTE
ILLUMI
P. CONT
ANT CONT
STEERING WHEEL
REMOTE INPUT
REMOTE CONT
White/Black
Gray/Black
Green/Black
Purple/Black
Speaker impedance: 4-8 Ω
Purple
Green
Gray
White
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker
Red (Ignition wire)
Black (Ground wire) ¤
(To car chassis)
Yellow (Battery wire)
To use the steering wheel remote
control feature, you need an exclusive
remote adapter (not supplied) matched
to your car.
Light Blue/Yellow
(Steering remote control wire)
Orange/White
(Dimmer control wire)
Brown (Mute control wire)
Blue
(Antenna control wire)
Blue/White
(Power control wire)
Connect to the terminal that is
grounded when either the telephone
rings or during conversation.
To use the Mute feature, you need to
hook up this wire to your telephone
by using a commercial telephone
accessory.
Depending on what antenna you are
using, connect either to the control
terminal of the motor antenna, or to the
power terminal for the booster amplifier
of the film-type antenna.
(Max. 300mA, 12V)
When using the optional power
amplifier, connect to its power control
terminal.
If no connections are made,
do not let the cable come out from the tab.
To steering remote
To car light control switch
Ignition key
switch
Car fuse
box
(Main fuse)
Car fuse
box
ACC
Battery
Accessory 1
Fuse (10A) Fuse (10A)
LVT2547-001C_14DNX_QSG_K_En.indd 23 14/02/04 15:22