Kenwood DNX691HD - Manual (Page 20)

20 ñ
English
Ñ GPS antenna
GPS antenna is installed inside of the car. It should
be installed as horizontally as possible to allow easy
reception of the GPS satellite signals.
To mount the GPS antenna inside your vehicle:
1) Clean your dashboard or other surface.
2) Remove the separator of the metal plate
(accessory -).
3) Press the metal plate (accessory -) down firmly
on your dashboard or other mounting surface.
You can bend the metal plate (accessory -) to
conform to a curved surface, if necessary.
4) Remove the separator of the GPS antenna
(accessory 0), and stick the antenna to the
metal plate (accessory -).
-
0
✎ NOTE
• Depending on the type of car, reception of the
GPS satellite signals might not be possible with
an inside installation.
• Please install this GPS antenna in an area away
from any antennas that are used with CB radios
or satellite televisions.
• The GPS antenna should be installed at a position
that is spaced at least 12 inch (30 cm) from
cellular phone or other transmitting antennas.
Signals from the GPS satellite may be interfered
with by these types of communication.
• Painting the GPS antenna with (metallic) paint
may cause a drop in performance.
Ñ Microphone unit
1) Check the installation position of the
microphone (accessory =).
2) Clean the installation surface.
3) Remove the separator of the microphone
(accessory =), and stick the microphone to the
place shown below.
4) Wire the microphone cable up to the unit with it
secured at several positions using tape or other
desired method.
5) Adjust the direction of the microphone
(accessory =) to the driver.
=
Fix a cable with a commercial item of tape.
LVT2547-001C_14DNX_QSG_K_En.indd 20 14/02/04 15:22