Appendix – Kenwood KDV-MP5343U User Manual
Page 31
English
|
31
Appendix
For operating KCA-BT200 (Optional)
For operation refer to Model-A-1 in the Instruction
Manual of KCA-BT200, and the table below. The
[AUTO]/[TI] button should be replaced with [SRC]
button for
Set the remote controller mode switch to “AUD” mode
before starting operation.
Notation used in the KCA-BT200
Instruction Manual
Operation
[
38] button
[AUD] knob*
1
Control knob
[AUD] knob
[AUTO]/[TI] button
[DISP] button
Control knob towards up or down
[FM+] or [AM–] button
Control knob towards left or right
[
4] or [¢] button
*
1
Use the [
38] button for the operation of Private Mode>. For operating KCA-BT100 (Optional) To control KCA-BT100, operate as follows; Displays of KCA-BT100 Instruction Actual displays on this unit “DISCONCT” “HF D-CON” “CONNECT” “HF CON” “PHN-DEL” “DVC-DEL” “HF-CON Y” “BT-CON N” “HF-CON N” Function Glossary • “AUTO1”, “AUTO2”, “MANUAL” (Tuning mode select) Select a tuning mode of the radio. Tuning mode Display Operation Auto seek “AUTO1” Automatic search for a station. Preset station seek “AUTO2” Search in order of the stations in the Manual “MANUAL” Normal manual tuning control. • “AVIN” (Audio/ visual input) selected. ON1: Allows AV input source to be selected. Use this setting when the built-in AV IN terminal is ON2: Activates the attenuator function when turning on the power with AV input source OFF: Disable AV input source selection. Use this setting when the built-in AV IN terminal is not • DTA (Digital Time Alignment) speaker output specified at of the reference point to the position of the ears 2 Measure the distances from the reference point to the speakers. 3 Calculate the distance difference in accordance with the farthest speaker. Next page 3 B64-4430-00_00_M_English.indd 31 B64-4430-00_00_M_English.indd 31 09.2.13 10:19:21 AM 09.2.13 10:19:21 AM
To make setting for
select
[AUD] knob for at least 1 second after selecting
the "D.MODE" item allows you to enter the dialing
method selection mode. To exit from dialing method
selection mode, press Search button.
To make
second.
Set the remote controller mode switch to “AUD” mode
before starting operation.
Moreover, some displays are different from the
description of KCA-BT100 Instruction Manual.
Manual
“P-STATUS” “D-STATUS”
“BT-CON Y”
Preset memory.
When this is set to ON, AV input source can be
connected to the external equipment all the
time.
selected. Cancel the attenuator function
by turning the volume knob clockwise
when listening to the audio of the external
equipment.
used.
Make fine adjustment of the delay time of the
(page 27) to have a more suitable environment for
your vehicle.
The settings of the delay time are automatically
identified and compensated by specifying the
distances of each speaker from the center of the
vehicle interior.
1 Set the front and rear positions and the height
of the person sitting in the front seat, and set
the right and left positions to the center of the
vehicle interior.