Notifier LCD2-80 User Manual
Lcd2-80, Liquid crystal display terminal mode annunciator, General
DN-60548:B2 • 05/25/12 — Page 1 of 2
LCD2-80
Liquid Crystal Display
Terminal Mode Annunciator
Annunciators
DN-60548:B2
JC
IL
C
D
2-
80.
jp
g
General
The LCD2-80 is a backlit LCD annunciator for the NOTIFIER
fire alarm control panels, or network control annunciators that
support the 80-character display format. LCD2-80s may be
connected onto the four-wire EIA-485 terminal port.
The LCD2-80 mimics the display of NFS2-640, NFS2-3030,
NFS-320, NCA-2 and legacy panels that supported the LCD-
80/LCD-80TM. The NFS2-3030 and the NCA-2 also support
LCD2-80s when set for LCD-80 supervision. Up to 32 LCD2-
80s can annunciate and provide remote reset, acknowledge,
drill and silence of the control panel from remote locations.
NOTE: The
LCD2-80 can be used with legacy panels that sup-
ported the LCD-80 terminal mode operation. Please refer to the
LCD2-80 manual for more information.
Features
• 80-character backlit Liquid Crystal Display (20 characters x
4 lines).
• Display mimics panel or NCA
– Event message.
– 20 characters for point label.
– 12 characters for extended label.
– Time, date and point address.
• Control switches for System Acknowledge, Signal Silence
Drill and System Reset.
• Up to 6000 foot segments between units.
• Local piezo sounder with alarm/trouble resound.
• Displays all analog, addressable points.
• Displays device type identifiers.
• Displays device and zone custom alpha labels.
• LCD2-80 mounts with any CHS-4 chassis slot.
• Slide-in label can be customized.
• LEDS for general off-normal events with UL 864 9th Edition
Panels.
NOTE: The LEDs are only applicable when used with UL 864
Ninth Edition listed panels: NFS-320, NFS2-640, NFS2-3030 and
NCA-2.
• Flush/surface/panel mount option.
• No programming necessary. LCD2-80 displays time, date,
and custom messages received from the compatible panel
or network annunciator.
• LCD2-80 is 8.25" (20.96 cm) high, 4.375" (11.11 cm) wide,
and 1.75" (4.45 cm) deep.
• Up to 32 LCD2-80s may be used on one EIA-485 circuit.
NOTE: Must have sufficient regulated 24 volt power.
NFS-320, NFS2-640, NFS2-3030, or NCA-2 connecting to LCD2-80
6,000 ft (1828.8 m)
Maximum wire length between each LCD2-80
EIA-485
(2 wires)
24 VDC
(2 wires)
EIA-485 return (2 wires)