Electrix Repeater - Manual (Page 45)

My MIDI foot controller doesn't line up with RepeaterÕs PC numbers. Some companies offset their PC numbers
to confuse the rest of us. Hooray! You may need to subtract one from the Program Change numbers in RepeaterÕs
MIDI chart to line up right with your floor controller.
I insert a CFC while playing and the CFC light just blinks red. It's an unformatted card. You need to stop
Repeater and reinsert the card to format it. ItÕs a card that is too slow to work with Repeater.
I try to record and all I get is a ÒTempo FastÓ or ÒTempo SlowÓ message. You need to adjust the tempo of the
loop into a range that Repeater can handle.
I remove the CFC and when I put it back in, the loop has lost my edits. Repeater saves parameters only after
coming out of record or when you change loops. Try changing loops before removing the card.
My loop speeds up. If you are in Beat Detect or MIDI sync modes Repeater will sync your loop to these sources. If
In different cases this could cause Repeater to speed the loop up to resync the beats. Putting Repeater into User sync
will prevent this.
After I resample my loop sounds different. After you resample, Pitch edits and the FX sends are still active. You
need to reset any Pitch shifting and disengage the FX insert or you will double up on the effect.
English... 45
TROUBLESHOOTING