Dake Model SAR 331 - Manual (Page 7)

7
SAR 331 SA GDS
4.3 - Minimum requirements for the premises
housing the machine
- Mains voltage and frequency complying with the machine motor
characteristics.
- Environment temperature from -10 °C to +50 °C.
- Relative humidity not over 90%.
4.4 - Anchorage of standard machine
- Position the machine on a firm cement floor, maintaining, at the
rear, a minimum distance of 1000 mm from the wall; anchor it to
the ground as shown in the diagram, using screws and expansion
plugs or tie rods sunk in cement, ensuring that it is sitting level.
4.5 - Instructions for electrical connection
- The machine is not provided with an electric plug, so the customer
must fit a suitable one for his own working conditions:
1 - WIRING DIAGRAM FOR 4-WIRE SYSTEM FOR THREE-
PHASE MACHINE - SOCKET FOR A 16A PLUG
R = L1
S = L2
T = L3
PE = GND
4.6 - Instructions for assembly of the loose parts and
accessories
Fit the components supplied as indicated in the photo:
- Mount the stock stop.
- Mount the coolant liquid holder.
4.7 - Disactivating the machine
- If the sawing machine is to be out of use for a long period, it is
advisable to proceed as follows:
1) detach the plug from the electric supply panel
2) loosen blade
3) release the arch return spring
4) empty the coolant tank
5) carefully clean and grease the machine
6) if necessary, cover the machine.
4.8 - Dismantling
(because of deterioration and/or obsolescence)
General rules
If the machine is to be permanently demolished and/or scrapped,
divide the material to be disposed of according to type and composi-
tion, as follows:
1) Cast iron or ferrous materials, composed of metal alone, are sec-
ondary raw materials, so they may be taken to an iron foundry
for re-smelting after having removed the contents (classified in
point 3);
2) electrical components, including the cable and electronic ma-terial
(magnetic cards, etc.), fall within the category of material classi-
fied as being assimilable to urban waste according to the laws of
the European community, so they may be set aside for collection
by the public waste disposal service;
3) old mineral and synthetic and/or mixed oils, emulsified oils and
greases are special refuse, so they must be collected, transported
and subsequently disposed of by the old oil disposal service.
4.2 - Transport and handling of the machine
If the machine has to be shifted in its own packing, use a fork-lift
truck or sling it with straps as illustrated.
INGOMBRO OPERATIVO = mm 2100
INGOMBRO OPERATIVO = mm 2300