Dake Model SAR 331 - Manual (Page 11)

11
SAR 331 SA GDS
7.5 - Blade-cleaning brush
This is an excellent accessory for cleaning the blade during the
cutting cycle. Periodically check brush integrity and if neces-
sary regulate further to guarantee perfect blade cleaning.
7.4 - Regulating the cutting angle
- Raise the frame to a position that avoids contact with the piece
supporting surface and the material to be cut.
- Push the lever (D) to the left in order to free the rotation device.
- Rotate the frame group to the necessary angle, referring to
the graduated sector.
- Use the mechanical stops on the machine base to make posi-
tioning at 45° / 60° easier. If necessary, rotate the mechanical
stops to permit movement of the rotating arm.
- When finished, push the lever (D) to the right in order to lock
the rotation device.
D
With this accessory it is possible to raise the frame and/or
move it closer to the piece to be cut.
- Use the selector (E) to move the frame to the necessary posi-
tion.
- It is advisable to position the blade at a distance of 10mm from
the material to be cut.
- To permit the frame lowering movement, open the hydraulic
regulator on the command panel.
7.7 - Regulating the cutting speed
The cutting speed should only be regulated while the belt rota-
tion motor is running.
Use the relative handwheel and refer to the relative plate in
order to set the necessary speed.
7.6 - Regulating the cutting height
SAR
1 2
START
E
POS. N° m/min.
0 21
1 23,5
2 26
3 28,5
4 31
5 33,5
6 36
7 38,5
8 41
9 43,5
10 46
11 48,5
12 51
13 53,5
14 56
15 58,5
16 61
17 62,5
18 64,5
POS. N° m/min.
19 66
20 68
21 71,5
22 74,5
23 78
24 81,5
25 85
26 87,5
27 90
28 93
29 96
30 99
31 102,5
32 105,5
33 108,5
34 111
35 113,5
36 116