Dake Model SAR 331 - Manual (Page 16)

16
SAR 331 SA GDS
the cutting of pipes and thin section bars (from 1 to 3 mm).
ALTERNATE SET (IN GROUPS): Groups of cutting teeth right and
left, alternated by a straight tooth.
This set is associated with very fine teeth and it is used for extremely
thin materials (less than 1 mm).
ALTERNATE SET (INDIVIDUAL TEETH): Cutting teeth right and left.
This set is used for the cutting of nonferrous soft materials, plastics
and wood.
Set
Saw teeth bent out of the plane of the saw body, resulting in a wide
cut in the workpiece.
REGULAR OR RAKER SET: Cutting teeth right and left, alternated
by a straight tooth.
Of general use for materials with dimensions superior to 5 mm. Used
for the cutting of steel, castings and hard nonferrous materials.
WAVY SET: Set in smooth waves.
This set is associated with very fine teeth and it is mainly used for
9.7.1 - RECOMMENDED CUTTING PARAMETERS
STEEL CUTTING SPEED LUBRICATION
CONSTRUCTION 60/80 EMULSIFIABLE OIL
CEMENTATION 40/50 EMULSIFIABLE OIL
CARBON STEEL 40/60 EMULSIFIABLE OIL
HARDENING AND TEMPERING 40/50 EMULSIFIABLE OIL
BEARINGS 40/60 EMULSIFIABLE OIL
SPRINGS 40/60 EMULSIFIABLE OIL
FOR TOOLS 30/40 EMULSIFIABLE OIL
FOR VALVES 35/50 EMULSIFIABLE OIL
STAINLESS STEEL 30/40 EMULSIFIABLE OIL
SPHEROIDAL GRAPHITE 20/40 EMULSIFIABLE OIL
CAST IRON 40/60 EMULSIFIABLE OIL
ALUMINIUM 80/600 KEROSENE
BRONZE 70/120 EMULSIFIABLE OIL
HARD BRONZE 30/60 EMULSIFIABLE OIL
BRASS 70/350 EMULSIFIABLE OIL
COPPER 50/720 EMULSIFIABLE OIL