Dake Model LE 13A - Manual (Page 8)

12/10/07 Model LE13A Text 8
LE13A
Item Metric English
Machine
Weight W
1492
Kg
3,290
lbs
Capacity, T 2 ton 2 ton
Length of the
Fork, L1
1.5
meters
59.06“
Distance
between fork,
L2
1.2
meters
47.24”
3.2 Preparation for installation
1. LEVELING: It is important to install the machine so that the rear most portion of
the main body table, feed table and roller bed is slightly raised. This prevents
cutting fluid from flowing backward along the material to be cut, especially long
material, and draining on the floor.
See Figure 3.3
Shim section B thicker than section A by 6mm. Shim section D thicker than section
E by 14mm. Horizontally, the table should be level or a little lower on the right.
If the table is higher on the right, recovery of the cutting oil will be slowed. The
height of the roller table, which is factory-adjusted, need not be re-adjusted. Be sure
the roller table is on the same level as the upper face of the feed table. Use a
straight edge to determine this. The roller face should be level with the feed table or
up to 0.12mm higher.
After the leveling is complete, check to make sure none of the steel sheets fail to
touch the floor due to overload.
REMOVING BRACKET FOR TRANSPORTATION: This bracket must be removed
before operating machine. Keep the bracket for use in moving the machine in the
future.
FIGURE 3.3