Summers Disk-Chisel - Manual (Page 23)

HITCH-LOCKS 9/17/2007 9CC3612-2008.iam/
B
8X0044
7/16" X 3-1/2"
8X0234
7/16" LNUT
8K1640
8T4000
8D8522
8X0223
1/4" FN
8K8067
8X0000
1/4 X 3/4"
8D8490
8D8500
8X0318
3/4" FW
8X0110
3/4 X 1.25"
8S1120
8S1126
8A1156
3/8 X 4-1/16 X 5"
8K8200
8S1124
8X0021A
8X0203
3/8" FN
8X0440
8X0402
8T4350
8S0340
1/2 X 4 X 5 1/4" SQ
8X0240
1/2" N
8X0303
1/2" LW
8T4380
14. Attach hitch to center with 1-1/2” x 10-5/8” pins.
NOTE: Center with 1-1/2” ID 10 GA fl at washers.
15. Install 7/16x3-1/2” retaining bolts through hitch pivot pins. Secure with lock nuts.
16. Attach hydraulic hose holder and tip holder with 3/4 x 1-1/4” bolt and fl at washer.
17. Attach hitch jack to jack spool.
18. Remove blocks from under center frame and allow wheel assemblies to support machine. Block
tires to prevent movement.
19. Add depth control cylinder locks and storage bases.
– Attach locks for rear cylinders by liftarm pivots located closest to center of machine.
– Locate lock for front center cylinder on front 4 x 4 tube.
20. Install SMV sign mounting bracket and sign at center of rear rank.
SECTION 2 – SET-UP OF DISK-CHISEL & COULTER-CHISEL CENTER SECTION (32’-36’)
2-11