11 alarms, 1 enable alarms, 2 alarm override time – Videoswitch CMOR D3 Dome User Manual
Page 24: 3 new alarm dwell, 4 alarm cycle time, Alarms, Enable alarms, Alarm override time, New alarm dwell, Alarm cycle time
CMOR Dome
Videoswitch Page
20
Vc607a.doc
10
For each new mask position, repeat steps 4 to 7
12
When all mask positions have been created , exit menus
& save by moving joystick left
4.11 Alarms
If the alarm option is installed in the power supply, the dome will go to presets when an
alarm occurs. Alarms 1 to 16 map to presets 1 to 16 respectively.
Note that if the alarms are connected directly to the digital recorder (DVR) rather than the
alarm option, the following settings have no effect.
4.11.1 Enable Alarms
4.11.2 Alarm override time
4.11.3 New alarm dwell
When a new alarm occurs, the dome will go to the corresponding preset.
If multiple alarms occur, the presets will be called up in sequence. However, the dome will
wait at each preset position for the dwell time set by this option (in seconds).
4.11.4 Alarm cycle time
If alarms still exist after all alarm presets have been visited for the New alarm dwell time, the
presets of the still active alarms will now be toured using the cycle time (in seconds)
specified in this option.