ADTRAN 4200659L1 - Manual (Page 151)

Chapter 9. Transaction Language 1 (TL1)
61200659L1-1 MX2800 STS-1 User Manual 9-5
The MX2800 STS-1 specifically uses “quoted line(s)” in REPT-
ALM and REPT-EVT autonomous messages. The REPT-ALM
message has the following quoted line format:
The NTFCNCDE field will contain one of the following values:
• CL - Alarm Cleared
• TC - Transient Condition
• MN - Minor
• MJ - Major
• CR - Critical
The REPT-EVT message has the following quoted line format:
The CONDEFF field will contain one of the following values:
• CL - Standing Condition Cleared
• SC - Standing Condition Raised
• TC - Transient Condition
For possible CONDTYPE codes for both REPT-ALM and
REPT-EVT quoted lines, refer to the condition types listed in Table
9-2 on page 9-10 and Table 9-3 on page 9-12, respectively.
See the section TL1 Autonomous Messages on page 9-10 for a list
of autonomous messages currently supported by the MX2800 STS-
1.
TL1 COMMANDS
As stated in TL1 Messages on page 9-2, the general format for a
TL1 command is:
:,,,,,…
:,,,,…
[-[-]]:[]:[]:[]:[GB](:(,)*)*;