ARI Armaturen DP34 EN - Manual (Page 11)

0040504000 1210 Page 11
Operating and installation instructions
Pneumatic actuators - DP32 / DP33 / DP34
4.5 Marking
5.0 Installation
5.1 General notes on installation
The following points should be taken into account besides the general principles governing
installation work:
Fig. 13
- Address of manufacturer: refer to item 12.0 Warranty / Guarantee
ATTENTION !
- Observe the information provided in the operating manual of the applicable
valve.
- Observe the information provided in the operating manuals of all components
(for ex. position adjuster, filter reduction station, interlocking relay ...).
- Valve (all included) with traverse.
- Observe the applicable current driving power and the provided line length of the
chosen line cross section.
- The actuator unit’s technical data must be in agreement with the requirements
for operation.
- The control air must be in accordance with the instructions given on the
nameplates of the actuator unit.
- The air quality should be in accordance with DIN IEC 60654-2.
- The actuator unit must be provided in full, with distance columns and coupling
parts, for the extension on the applicable valve.
- Personnel with knowledge of the rules and regulations is required for the
construction of the compressed air system.
Manufacturer
Mode of
Travel
Figure-Number Type
min. necessary
operation
operating pressure
Costumors
specification
Serial-No.
Year of manufacture clear speach
(1. and 2. position)
max. permissible
operating pressure
Spring range