Vaisala MMT310 - Manual (Page 50)

User's Guide _______________________________________________________________________
50 ___________________________________________________________________ M210474EN-C
Reset Transmitter
Syntax: RESET
This command resets the device, resulting in a short start-up delay. The
serial interface mode (STOP, RUN or POLL) selected with the SMODE
command is taken into use at restart.
Display Error Messages
Syntax: ERRS
Display transmitter error messages. If there are no errors present,
a PASS will be returned.
Examples:
>errs
PASS
>
>errs
FAIL
Error: Temperature measurement malfunction
Error: Humidity sensor open circuit
>
In case of a constant error, please contact a Vaisala Service Center.
For information on contacting Vaisala Service Centers, see
www.vaisala.com/servicecenters .