Vaisala PTB200 - Manual (Page 18)

PTB 200 17 (28)
Digital Barometers
SSD/Operating Manual 24th February 1993 PTB200-O0284-1.1
ADDR Setting the barometer address (for POLL mode only)
ADDR
ADDR is used to set or inspect an address (1...99) of a barometer for
the POLL mode.
Example of setting the address 7:
>ADDR
Address : 0 ? 7
A new address replaces the previous address. Always set the address
to 0 when no address is needed:
>ADDR
Address : 7 ? 0
If the barometer is not in the POLL mode, it will respond to any SEND
command regardless of if there is an address or not. See SMODE and
SEND commands for further details.
SCOM Setting a user defined command for single reading
output
(STOP and RUN modes only)
SCOM
is used to define a new command for single reading output in the STOP
and RUN modes. A command defined by SCOM command does not
work in the POLL mode. The SEND command is always available.
Example of a command definition:
>SCOM P
>P
(a single pressure reading appears)
A new SCOM command replaces the previous definition.