State 520 - Manual (Page 36)

Normal Operation
36
│
Page
 The water heater will display the set temperature on the 3‐digit 7‐Seg.
LED on the computer board. This LED is visible through a small window
on the unit’s front cover.
 If the remote controller is installed, refer to the remote controller
Installation Manual included with the remote for setting temperature.
 Flow rate to activate the water heater : 0.5 gallons per minute at the
default set temperature
 Flow rate to keep the water heater running : 0.4 gallon per minute
H ot Water temperatures over 125F can cause severe burns instantly
or death from scalding.
 The outlet hot water temperature of the water heater is factory set at
120F.
 Feel the water temperature before bathing or showering.
NORMAL OPERATION
GENERAL
1. Open a hot water tap.
2. Mix cold water with the hot to get
the correct temperature water.
3. Close the hot water tap.
WARNING
TEMPERATURE SETTINGS
‐ON THE WATER HEATER‐
On the water heater, changing the temperature setting can be done simply by using the 3‐digit 7‐seg.
LED, and the “Increase” and “Decrease” buttons on the computer board (remote controller is not
required)
WARNING