State SBB75 76NE - Manual (Page 10)

10
5. Wait five (5) minutes to clear out any gas.
If you then smell gas, STOP! Follow "B" in
the safety information above on this label.
If you don't smell gas, go to next step.
6. Turn on all electrical power to the appliance.
7. Set thermostat to desired setting by first pressing the
COOLER and HOTTER buttons together and
holding for 1 second. Then press the HOTTER
button.
8. If the appliance will not operate, follow the
instructions "TO TURN OFF GAS TO APPLIANCE"
and call your technician or gas supplier.
9. WATER TEMPERATURE ADJUSTMENT
is approximately 120°F (49°C).
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
• If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in the control buttons.
Never use tools. If the control buttons will not push
in, don’t try to repair them, call a qualified service
technician. Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
OPERATING INSTRUCTIONS
A. Set thermostat to the lowest setting.
B. Turn off all the electric power to the appliance
if service is to be performed.
TO TURN OFF GAS TO APPLIANCE
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
1. STOP! Read the safety information above
on this label.
2. Set the thermostat to the lowest setting by first pressing
the COOLER and HOTTER buttons together
and holding for 1 second. Then press the COOLER
button until the WARM indicator light appears.
3. Turn the "ON/OFF" swich on the blower control to the
"OFF" position.
4. This appliance is equipped with a device which
automatically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
A. This appliance does not have a pilot. It is equipped with
an ignition device which automatically lights the burner.
Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
CAUTION: Hotter water increases the risk
of scald injury. Consult the instruction
manual before changing temperatures.
WARNING: TURN OFF ALL ELECTRIC
POWER BEFORE SERVICING