Auto Page autopage RS-850lcd User Manual

Page 7

JAN/07/2003

RS850 OP

System Arm

Door Ajar

Trunk / Hood Ajar

Clear The Flash Icon:

Press the

button 3

times within 3 seconds
will clear the flash icon
on
the LCD screen
transmitter.

DEFECTIVE SENSOR REMINDER: If the siren sounds 3 chirps, then you have
left a door, trunk, or hood
lid ajar. (See Alarm Feature “I - 4 Programming)

SILENT ARMING / DISARMING: Press the transmitter

and

button at

the same time will arm or disarm your security system, No chirp sound will
be heard, arm / disarm confirmation will be through the vehicles parking
lights only.

SHOCK SENSOR BY-PASS: Press the

button on the transmitter two times

within 3 seconds will arm the security system and by-pass the shock sensor.
The system will chirp one additional time to confirm the sensor bypass
mode was activated. The sensor bypass feature is programmed to activate
for one arming cycle only. The security system will return to normal operation
during the next arming cycle.

H. PASSIVE ARMING

Active arming / disarming is controlling your security system via the remote
transmitter. This security system is equipped with an optional Passive
Arming feature, which allows the security system to arm 30 seconds after the
last door is closed. Operation is as follows.

1. Turn the ignition to the “OFF” position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30

seconds. If you reopen any door / hood / trunk, the security system LED
will stop flashing. It will begin flashing again once the vehicle all entrances
are closed.

3. After 30-second timer has elapsed, the security system will automatically

“ARM”. The siren will chirp [1] time and the parking lights will flash [1] time.

PASSIVE ARMING WITH PASSIVE DOOR LOCKING (See Alarm Feature “I -
2” Programming):

The vehicle doors will automatically lock after passive arming cycle has
been completed.

PASSIVE ARMING BY-PASS: While the system disarmed, Press the

buttons twice, the security will respond with [1] chirp and LED will turn “ON”.
The security system will remain in this temporary state for as long as you

wish. To exit passive by-pass, press the transmitter

button and

the system will return to normal status.