State GS6 65 XRRT - Manual (Page 21)

Use this guide to check a “Leaking” water heater. Many
suspected “Leakers” are not leaking tanks. Often the
source of the water can be found and corrected.
If you are not thoroughly familiar with gas codes your
water heater, and safety practices, contact the gas utility to
check the water heater.
Water at the draft hood is water vapor which has
condensed out of the combustion products. This is
caused by a problem in the vent. Contact the gas
utility.
*Condensation may be seen on pipes in humid
weather or pipe connections may be leaking.
*The primary anode rod fitting may be leaking.
Small amounts of water from temperature-pressure
relief valve may be due to thermal expansion or
high water pressure in your area.
*The temperature-pressure relief valve may be
leaking at the tank fitting.
Water from a drain valve may be due to the valve
opened slightly.
*The drain valve may be leaking at the tank fitting.
Combustion products contain water vapor which
can condense on the cooler surfaces of the tank.
Droplets form and drip into the fire or run on the
floor. This is common at the time of startup after
installation and when incoming water is cold.
Water in the water heater bottom or on the floor
may be from condensation, loose connections, or
the relief valve. DO NOT replace the water heater
until a full inspection of all possible water sources
is made and necessary corrective steps taken.
Leakage from other appliances, water lines, or
ground seepage should also be checked.
A
B
C
D
E
F
I
H
G
*To check where threaded portion enters tank, insert cotton swab between jacket opening and fitting. If cotton is wet, follow
“Draining” instructions in the “Periodic Maintenance” section and then remove fitting. Put pipe dope or teflon tape on the
threads and replace. Then follow “Filling the Water Heater” instructions in the “Installing the New Water Heater” section.
Leakage Checkpoints
21
CAUTION
Read this manual first. Then before checking the water heater
make sure the gas supply has been turned “OFF”, and never
turn the gas “ON” before the tank is completely full of water.
CAUTION
Never use this water heater unless it is completely filled with
water. To prevent damage to the tank, the tank must be filled
with water. Water must flow from the hot water faucet before
turning “ON” gas to the water heater.