Checkers Cross Guard Access Ramps and Rails - Manual

HEAVY DUTY
ADA COMPLIANT ACCESS
RAMPS AND RAILS
LOAD CAPACITY:
CROSS-GUARD ADA compliant access ramp load supporting capabilities could
vary depending on type of vehicle and temperature. Suitability must be verified
by testing under actual conditions.
OPERATING TEMPERATURE:
-40 ˚ F to 120 ˚ F (-40 ˚ C to 48 ˚ C)
CHEMICAL RESISTANCE:
Tested for compatibility with common motor oils, gasoline and
diesel fuel. Limited resistance to brake fluids and other chemicals.
MATERIAL:
UV-stabilized polyurethane elastomer
#ZIS-CPRP
Ver: 2/11
A D A A C C E S S C O M P L I A N T
®
FOR USE WITH SELECT LINEBACKER, GUARD DOG, AND SIDE-KICK CABLE PROTECTORS*
ASSEMBLY:
• Modular, 36-inch wide ramps can be attached to single or multiple cable
protectors in series to provide an ADA compliant access ramp of any length.
• Side rails provide required edge protection to prevent wheelchairs from rolling off
ramp sides.
• ADA ramps and rails attach only to the existing cable protector ramps and do not
interfere with the operation of the cable protector lid and accessibility of the
electrical cables.
• Lightweight modular design allows for quick and easy assembly by one person.
• Gentle slope and slip resistant ramps provide an excellent crossing point for carts
and vehicles with small wheels.
ADA
COMPLIANT
Ramps
ADA SYSTEMS
MAXIMUM LOAD PER AXLE
70˚F (21˚C)
21,000 lbs. (9,526 kg)
MAXIMUM LOAD PER TIRE
70˚F (21˚C)
10,500 lbs. (4,763 kg)
COMPONENTS
Modular components
allow you to create an
ADA system of any length
ADA RAIL CAN BE
USED IF REQUIRED.
CABLE PROTECTOR
CABLE PROTECTOR
RAMP
RAMP
RAMP
RAMP
Shown with Guard Dog Cable Protectors
WARNING!
Cross-Guard ramps and rails are compatible only
with Linebacker and Guard Dog cable protectors as
specified. Cross-Guard ramps are also compatible
with Side-Kick cable protector expanders. Improper
use with other cable protector brands may result
in product failure or injury.
*
RAIL BARRIERS AVAILABLE IF NEEDED
For additional stability, it
is recommended that two 75
pound weights (for a total
weight of 150 pounds) be placed in
the recessed areas of each Rail Barrier.