ADTRAN HDSL2 - Manual (Page 32)

Control Port Operation HDSL2 for General Distribution Installation and Maintenance Practice
22 61223HDSL2L2-5B
Provisioning
The Provisioning menu (
Figure 16 ) displays current settings. To change a particular option
setting (for example, “1” for DSX-1 Line Build Out) select the appropriate number, press
E NTER ,
and the new menu will appear with a list of the available settings. To return to this screen
and/or the Main Menu, press
E SC
. To re-deploy this unit, press
D
which will restore the factory
default settings to those shown in Table 6 on page 11.
Figure 16. Provisioning Screen
NOTE
DSX-1 Line Build Out is set to 0-133 feet. This option is set to
EXTERNAL if using a Kentrox shelf. Otherwise, the LBO option
should be set to zero (0).
NOTE
Shelf Alarm option is on the DDM+ and 3192 modules only.
Total Access 3000 H2TU-C Provisioning Menu
Two screens comprise the provisioning menu for the Total Access 3000 H2TU-C.
Figure 17
illustrates the first page of the menu.
Press the
N
(and
E NTER
) to move forward to the next screen. Figure 18 shows the remainder of
the Provisioning menu.
To return to the previous screen, press
P
.
To return to the Main Menu, press
E SC
.
Circuit ID:HNTSVLALHDSL2 03/01/05 09:29:45
Press ESC to return to previous menu
Provisioning
1. DSX-1 Line Buildout = 0-133 feet
2. DSX-1/DS1 Line Code = B8ZS
3. DSX-1/DS1 Framing = ESF
4. Forced Frame Conversion = Disabled
5. Smartjack Loopback = Enabled
6. Loopback Timeout = 120 Minutes
7. Latching Loopback Mode = T1 (Disabled)
8. DS1 TX Level = 0 dB
9. Span Power = Enabled
10. Customer Loss Indicator = AIS / CI
11. PRM Setting = AUTO
12. Loop Atten Alarm Thres = 30 dB
13. SNR Margin Alarm Thres = 04 dB
14. Remote Provisioning = Enabled
15. Shelf Alarm = Enabled
D. Restore Factory Defaults
Selection: