Outback Power Systems GFX Series Inverter/Charger Operators Manual - Manual (Page 50)

Specifications
48
900-0114-01-00 Rev A
Table 17 12-Volt Inverter Settings
12 Vdc Inverter Default Minimum Maximum
Diversion On Voltage 14.6 Vdc 12 Vdc 16 Vdc
Diversion Off Delay 30 sec 0 sec 240 sec
Stacking
Stack Phase Master Master, Classic Slave, OB Slave L1, 3p Classic B,
or 3p Classic C
Power Save Level
Master Adjust Only 0 0 7
Slave Adjust Only 1 1 15
Sell
Sell RE Volts 13.0 Vdc 10 Vdc 15 Vdc
Grid Tie Window User IEEE or User
Grid Tie Authority GridTie GridTie or No Sell
Calibration (Cal)
Vac Input Adjustment1 236 220 254
Vac Output Adjustment1 236 220 254
Battery Vdc Adjustment2 2 0 4
1These values are in digital counts, not volts. Lower counts stand for higher voltages, and higher counts mean lower
voltages. One count equals approximately 1 Vac. The range of adjustment is 15 Vac above nominal, and 17 Vac
below nominal.
2 These values are in digital counts, not volts. One count equals 0.1 Vdc. The range of adjustment is 0.2 Vdc above or
below nominal.
Table 18 24-Volt Inverter Settings
24 Vdc Inverter Default Minimum Maximum
Search
Search Sensitivity
(see page 14 for increments)
6 0 50
Search Pulse Length 8 4 20
Search Pulse Spacing 60 AC cycles 4 AC cycles 120 AC cycles
Input
AC Transfer Control Grid Grid or Generator
AC1/Grid Limit 50 Aac 5 Aac 60 Aac
AC2/Gen Limit 50 Aac 5 Aac 60 Aac
Inverter
Low Battery Cut-Out (LBCO) 21 Vdc 18 Vdc 24 Vdc
Low Battery Cut-In (LBCI) 25 Vdc 20 Vdc 28 Vdc
Adjust Output Voltage 120 Vac 110 vac 130 Vac
Charger
Charger Limit 11 Aac 0 Aac 12 Aac
Absorb Voltage 28.8 Vdc 26 Vdc 32 Vdc
Absorb Time Limit 1.0 hours 0.0 hours 24.0 hours
Float Voltage 27.2 Vdc 24 Vdc 30 Vdc
Float Time Period 1.0 hours 0.0 hours 24.0 hours
ReFloat Voltage 25 Vdc 24 Vdc 26 Vdc
Equalization Voltage 29.2 Vdc 28 Vdc 34 Vdc
Equalization Time Period 1.0 hours 0.0 hours 24.0 hours